Product Manual

SECTION 1—GENERAL GUIDELINES
ValueCare Bed Series 10 Part No 1134867
 ENTRAPMENT WARNING
Proper patient assessment and monitoring, and proper maintenance and use of
equipment is required to reduce the risk of entrapment. Variations in bed rail
dimensions, and mattress thickness, size or density could increase the risk of
entrapment. Visit the FDA website at http://www.fda.gov to learn about the risks of
entrapment. Review “A Guide to Bed Safety”, published by the Hospital Bed Safety
Workgroup, located at www.invacare.com. Use the link located under each bed rail
product entry to access this bed safety guide.
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Assist rails with dimensions different from the
original equipment supplied or specified by the bed manufacturer may not be
interchangeable and may result in entrapment or other injury.
Mattress MUST fit bed frame and assist rails snugly to reduce the risk of entrap-
ment.
Replacement Parts/Accessories
Use masked or nasal type oxygen administering equipment only in conjunction with this
bed. The use of any other type of oxygen administering equipment can result in a fire
hazard.
When using nasal or masked type oxygen administering equipment, the oxygen or air
tubing MUST be routed and secured properly to ensure that the tubing does not become
entangled and/or severed during normal operation of the bed.
Always test to make sure that the side rails are properly and securely in place before using
the electric bed.
Invacare recommends that the mattress be centered on the bed frame. Otherwise,
individuals may become entangled between the bed rail and the bed frame.
Physically challenged individuals who cannot prevent themselves from rolling/climbing
out of the this bed may require alternative safe means of restraint.
After raising/lowering the head/foot end of the electric bed, check the distance between
the bottom of the bed rail and the mattress. If there is excessive distance between the
bottom of the bed rail and the mattress in which individuals may become entangled,
adjust the height of the bed rail (if applicable), or provide alternative means of patient
protection.
DO NOT use the side rails as push handles for moving the electric bed.
Traction units MUST be securely fastened to head/foot ends of the bed. These units are to
be used only for immobilizing a patient in various traction setups or assisting the patient
in repositioning or transferring in or out of the bed.
Trapeze units are to be used only for immobilizing a patient in various traction setups or
assisting the patient in repositioning or transferring into or out of bed.