Product Manual

SECTION 1—GENERAL GUIDELINES
ValueCare Bed Series 12 Part No 1134867
Electrical
 DANGER
When using an extension cord, use only a three wire extension cord having at least
16 AWG (American Wire Gauge) wire and the same or higher electrical rating as
the device being connected. Use of improper extension cord could result in a risk of
fire and electric shock. Three prong to two prong adapters should not be used. Use
of three prong adapters can result in improper grounding and present a shock haz-
ard to the user.
DO NOT unplug power cord from motor housing.
If a liquid is spilled in or around the electric bed, unplug the electric bed before cleaning.
Clean up the spill and allow the electric bed or the area around the electric bed to dry
thoroughly before using the electric controls again.
The pendant and power cords MUST be routed and secured properly to ensure that the cords
DO NOT become entangled, pinched and/or severed during operation of the electric bed.
NEVER operate if the unit has a damaged cord or plug. If it is not working properly, call
a qualified technician for examination and repair.
Keep all electrical cords away from heated or hot surfaces.
Ensure all cables and cords are routed such that they will not become entangled or
pinched. Otherwise, damage or injury may result.
NEVER operate the unit if these cords are damaged.
Refer servicing to qualified personnel only. Grounding reliability depends upon a
properly grounded wall outlet.
Repair or Service Information
DO NOT open assemblies such as the motor, pendant, or gear boxes. No user serviceable
parts are inside. Only qualified technicians are permitted to repair these parts. If
unqualified individuals perform any work on these beds, the warranty is void.
Unplug the power cord from its power source before performing any maintenance on the bed.
Servicing of Double-Insulated Products
In a double-insulated product, two systems of insulation are provided instead of
grounding. No grounding means is provided on a double-insulated product, nor is a
means for grounding to be added to the product. Servicing a double-insulated product
requires extreme care and knowledge of the system, and is to be done only by qualified
service personnel. Replacement parts for a double-insulated product MUST be identical
to the parts they replace. A double-insulated product is marked with the words
"DOUBLE INSULATION" or "DOUBLE INSULATED". The symbol ( ) is also able to be
marked on the product.