Product Manual

SECTION 4—PACKAGING, HANDLING, AND SET-UP

Part No 1134867 23 ValueCare Bed Series

Installing the Casters

 WARNING

Ensure that the two locking casters are installed diagonally opposite from each

other and are locked. Otherwise, damage or personal injury could occur. Refer to

Detail “A” in FIGURE 4.3.

Ensure that casters are locked and that the bed does not move before transferring.

DO NOT transfer occupant if bed is not stable.

NOTE: For this procedure, refer to FIGURE 4.3.

NOTE: If optional casters were purchased and two locking casters are not included with the bed,

contact a qualified dealer.

1. Install casters by carefully lifting the bed ends approximately five inches (12.7 cm)

from the floor and inserting the shaft of caster assembly into the caster socket.

2. To prevent excess movement of the bed, lock each of the two locking casters by

pushing down on the side of the caster lock that is labeled on.

NOTE: Locking the casters may not prevent the bed from moving on slick or slippery surfaces.

3. To unlock each of the two locking casters by pushing down on the side of the caster

lock that is labeled off.

FIGURE 4.3 Installing the Casters

Non Locking

Caster

Unlocked

Caster

Shaft

Locking

Caster

Socket

Locked

Universal Bed End

Locking

Caster

Locking Caster

DETAIL “A”