Product Manual

SECTION 4—PACKAGING, HANDLING, AND SET-UP
ValueCare Bed Series 26 Part No 1134867
Installing the Battery for Emergency Operation
 WARNING
Battery is to be used for lowering bed only. Battery MUST be replaced after using
or at least every twelve months.
NOTE: For this procedure, refer to FIGURE 4.6.
1. Install 9V battery into battery mount location.
2. Connect 9V battery to the connector lead coming out of the motor.
FIGURE 4.6 Installing the Battery for Emergency Operation
Installing the Bed Ends
NOTE: For this procedure, refer to FIGURE 4.7 on page 27.
NOTE: The bed ends are universal and can be mounted to the head or foot end of the bed.
1. Stand one bed end as close to the head spring section as possible.
2. With one hand, grasp the head spring section and raise until the rivets on the corner
plates are at the correct height to fit into the corner locks on the bed end.
 WARNING
DO NOT place your hand between the head spring section and the bed end while
assembling, otherwise injury may occur.
3. Tilt the bed end backward slightly and the rivets should slide into the corner locks
more easily.
4. When the bed end is returned to its full upright position, the bed end will lock into
place.
5. Repeat STEPS 1-4 to install the remaining bed end to the foot spring section.
Motor
Connect 9V
Battery Here
Battery Mount