Manualshelf

Quick Start Guide

ManualsBrandsInvenco ManualsElectronicsOutdoor Contactless Card Payment Module (Secure Contactless Controller)
12345678
Table Of Contents
2-4
DCV-00617 S2 R01
Installation
2.1 Installing the SCC
The SCC is designed as a drop-in replacement for the existing NFC antenna and LED contactless reader module. To
install the SCC:
1. Disconnect the NFC contactless reader and LED cables from the UPC.
2. Remove the contactless reader.
3. Fit the SCC in place of the contactless reader.
4. Remove the USB cable connecting the APC to the SDC.
5. Connect the SCC's USB 'A' cable to the APC.
6. Connect the SCC's USB 'B' cable to the SDC.
The following connection diagram illustrates the physical architecture and the simple retrofit.
2.2 Next Steps
1. Check that all other G7-100 parts are correctly installed, according to Quick Start Guide: G7-100 Vendor
Development OPT (DCV-00513).
2. Install the correct version of firmware according to the steps outlined in chapter Installing Packages of User
Guide: TMSLite (SocketTAL) (DCV-00277).