User's Manual
barcode for multiple times. Click button “Stop” to stop scanning. The scanning result will be displayed
as shown below. The scanning state (including amount of tags that have been read, total scanning times,
successful scanning times and reading rate) will be displayed under the table.
Figure 2-27 Barcode-scanning results
Note: if reading barcodes failed, please adjust the position including angle and distance of the reader
towards the barcode.
l Clear: to clear the results.
2.4.2 Option
Click button “Option” on read barcode interface, as shown below:
Figure 2-28 Settings
l Yes: perform the settings.
l Type: to select the type of barcode imager. The available options are Honeywell 1D and Honeywell
1D/2D.
l Loop read: tick the option “Interval(s)” to set loop read.
l Interval: the interval of loop reading, measured by seconds.
l OK: to perform the settings and return to read barcode interface. Then, loop reading begins by
clicking “read” (the button will transfer to “Stop” after clicking). The reading status (reading times,
successful times and failed times) will be displayed at the bottom of the read barcode interface.
Loop reading can be stopped by clicking “stop” (the button will transfer to “read” after clicking).