User's Manual

Figure 2-2 RFID interface
l Clear: To clear the scanning results in the table.
l Read: To perform loop reading.
l Option: To set reader parameters and tag operations.
Click the button “Scan” (the button will be transferred to “Stop” after clicking), the reader will perform
loop scanning. That means a tag will be scanned for many times. Then, the data and scanning times of
the tag will be listed in the table. The loop scanning will not be stopped until you click the button “Stop”
(the button will be transferred to “Scan” after clicking). The example is shown as figure 2-3.
Note: scanning can also be performed by pressing the key [SCAN] on the RFID handheld reader.
Figure 2-3 read
As shown in the figures above, the scanning state (including reading time, reading rate and tag amount)
will be displayed under the table.
If the data of the last time is not cleared, the current scanning data will be added to the previous data.
In the same word, the scanning times will be added to the value displayed at the last stop instead of 0.
If you would like to count the scanning times from 0, please click “Clear”. Then, the data of the last
scanning will be cleared and could perform a new time of scanning.
The software is set to read TID of tags in default. The reading settings could be changed in “Read set”.
Click “Option”, the interface is shown as figure 2-4.
Figure 2-4 RFID option
The read settings and other settings will be introduced in detail below.