User's Manual

User Manual
XC2907-A Portable Reader
18
2) Prompt tone: Check to open the card reading sound of handset.
3) RSSI: Check to display RSSI value.
4) Operation type: Set the card reading type.
Option Description
Single After opening the reading card, read the tag only once.
Cycle After opening the reading card, read all tags in cycles.
5) Tag type: Set the type of read tag.
Option Description
6C Only read 6C tag
6B Only read 6B tag
6C&6B Read 6C and 6B tags
GB Only read GB tag (XC2907-A does not support the operation)
6) Read EPC: Only read EPC area of the tag.
7) Read TID: Only read TID area of the tag.
8) General reading: Read EPC, TID and user area.
9) TID Length: Set the TID length to be read.
10) User data initial address: Set the initial address to read the user area.
11) User data length: Set the reading length of data in the user area.
Notes: TID length, user rst data address, user data length can only be set when
they are available.
6.4.2 Power setting
The mode to enter the power setting is "menu" and "power setting." The detailed
introduction can be shown in Figure 6-5:
6. Introduction for RFID module