User's Manual

User’s Manual to XCRF-502E Reader
Internal use.only. Any transmission is not
allowed without permission.
19
The minimum safety distance to potential positions with human
activity must be first considered at the time of installing the antennas.
5.2.2 Check the Working Settings
If the network communication mode was chosen, set the network
parameters via the serial port and check if there is any mistake before
installation (No collision between IP and other devices in the same
network segment).
5.3 Network Setting
How to complete XCRF-502E Reader’s Ethernet connection and
settings is introduced in this section.
TCP/IP protocol is followed in the network settings of XCRF-
502E Reader.The network settings of XCRF-502E Reader is
configured via demo software. See the operation introductions of
Demo Software for XCRF-502E Reader in the following chapters.
5.3.1 Communication Mode Setting
Click the icon “XCRF-502E Series Reader Demo” at the directory
of installation, and run the software directly.The display interface of
Demo Software is illustrated in Fig. 5.1: