User's Manual

User’s Manual to XCRF-502E Reader

Internal use.only. Any transmission is not

allowed without permission.

Check whether the installation conforms to the

corresponding requirements, and whether the connections

among the devices are OK.

Þ Whether the Reader is fixed and not loose;

Þ Whether all the cables are tightly connected and

fixed;

Þ Whether the screws are tightened.

See Installation Precautions for other information.

5.9.2 Performance

Whether the Reader works normally depends on two aspects:

1. Prepare some 6B tags, and connect the antenna, power cable,

network cable and cross serial port cable to the Reader;

2. After the Reader is power on, the power supply indicator

lamp is on and the buzzer gives off two sounds;

3. Connect Demo Software to the Reader via network port or

serial port to use the software.

4. Select “Read card continuously”; the tag ID will be read

continuously in the range of 5 to 7m right in front of the

antenna with the time intervals of 30ms;

5. Power supply lamp, power amplifier lamp, read card lamp

and antenna lamp will give correct indications when reading

card or implementing other operations.

6. Read data and write data to the tags correctly;