User's Manual

CM-G100 Usermanual/Datasheet
Jun 08, 2009 Confidential Page 4 of 10
1. Overview
Thank you very much for choosing this product. Please carefully read this Operation Manual before use
CM-G100. Please keep the Operation Manual well after reading.
1.1 About the Product
z It is GSM-SIM card and it is an independent miniature module of GSM’s wireless communication part.
z The operation method is different from the corresponding products. So please refer to the Operation
Manual of every product.
z This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
z Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
z Some electronic devices are susceptible to electromagnetic interference sent by this equipment if
inadequately shielded. Please use this equipment at least 20cm or as far as you can from TV set, radio and
other automated office equipment so as to avoid interference.
z This device is a radio transmitter and receiver. It is designed and manufactured not to exceed limits for
exposure to radio frequency (RF) energy set by the Federal Communications Commission (FCC) of the
U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF
energy for the general population. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation of scientific studies. The
standards include a substantial safety margin designed to assure the safety of all persons, regardless of
age or health.
z The maximum antenna gain which is allowed for use with the device for mobile or fixed operating
conditions should not exceed 5dBi.
z This device is to be used only for fixed and mobile applications. If the final product after integration is
intended for portable use, a new application and FCC is required. The antenna(s) used for this transmitter
must be installed to provide a separation distance of at least 20cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.
z This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/ TV technician for help.