Manualshelf

Data Sheet

ManualsBrandsInventek Systems ManualsElectronicsBLE 5.0 Radio Module for Portable or Mobile config
12345678910
ISM14585-L35 Specification
DOC-DS-14585-201807-3.0
Confidential Inventek Systems
Page 10
3.3 Key Benefits
• Lowest power consumption
• Smallest system size
• Lowest system cost
3.4 Limitations
Inventek Systems products are not authorized for use in safety-critical applications
(such as life support) where a failure of the Inventek Systems product would
reasonably be expected to cause severe personal injury or death.
3.5 Regulatory Compliance
CE
Regulator
Status
FCC
O7P-14585
IC
10147A-14585
RoHS
Compliant
Inventek Systems FCC, IC, and CE modular transmitter certifications for the ISM14585-L35
SiP can be used to the advantage of any manufacturer developing a product using these
devices. In order to take full advantage of the certifications and remain in compliance,
Developers may not interfere, modify, replace and/or enhance the SiP antenna design, layout
and power settings. For FCC compliance, End Customer finished products will still need to meet
the Declaration of Conformity (SDoC) requirements according to 47 CFR Chapter 1, part 15,
subpart B.
The testing required for the Declaration of Conformity (SDoC) requirements is specified in
sections 15.107 and 15.109. The official documents can be oained from the U.S Government
Printing Office online. U.S. Government Printing Office CFR 47.
If it is desired to add a connector or U.FL connector in the RF path or change the antenna to
one of the same type (chip) with equal or less gain, customers can do so without refiling.
Other changes such as a different antenna or adding an antenna diversity switch will require
filing for a Class 2 permissive change. Any Class 2 permissive changes must be performed
under Inventek’s grant, and therefore must be done in cooperation with Inventek. In addition to
this document, Inventek recommends verifying the schematic board design with Inventek
Engineering once the schematic is complete for further review and validation.
Inventek also provides customers additional certifications for specific countries upon request
and an agreed upon service fee.