Data Sheet

ISM14585-L35 Specification
FCC and IC Regulatory Information
Model (HVIN): ISM14585-L35-P8
Product Marketing Name (PMN): ISM14585
FCC ID: 07P-14585
IC: 10147A-14585
This module is limited to OEM installation only.
OEM integrators must ensure that the end-user has no manual instructions to remove or
install the module.
OEM’s must comply with FCC marking regulation part 15 declaration of conformity (Section
2.925(e)).
This module is to be installed only in mobile or fixed applications (Please refer to FCC CFR
47 Part 2.1091(b) for a definition of mobile and fixed devices).
Separate approval is required for all other operating configurations, including portable
configurations with respect to FCC CFR 47 Part 2.1093, and different antenna
configurations.
The antennas used with this module must be installed to provide a separation distance of at
least 20cm from all persons, and must not be co-located or transmit simultaneously with any
other antenna or transmitter, except in accordance with FCC multi transmitter product
procedures. The ISM14585 Module has been designed to operate with the following
antennas and gains. Use with other antenna types or with these antenna types at higher
gains is strictly prohibited.
Manufacturer Type of
Antenna
Model Gain dBi Type of
Connector
Inventek Integrated N/A -1 embedded
Inventek Trace B24P-W +3.2 W.FL
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions.
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.