Data Sheet

ISM14585-L35 Specification
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures: —
Reorient or relocate the receiving antenna. —Increase the separation between the
equipment and receiver. —Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. —Consult the dealer or an experienced radio/ TV
technician for help.
This equipment complies with FCC RF Exposure requirements and should be installed and
operated with a minimum distance of 20cm between the radiator and any part of the human
body.
A clearly visible label is required on the outside of the user’s (OEM) enclosure with the
following text:
Contains FCC ID: O7P-14585
Contains IC: 10147A-14585
This transmitter module is certified for FCC Part 15 operation; when installed in a host
device, the host manufacturer is responsible for making sure that the host device with the
transmitter installed continues to be compliant with Part 15B unintentional radiator
requirements.
RSS-210/RSS-Gen Notices-
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of this device.
L’opѐ ration est soumise aux deux conditions suivantes: (1) cet appareil ne peut pas
provoquer d’interfѐ rences et (2) cet apparial doit accepter toute interfѐ rence, y compris les
interfѐ rences qui peuvent causer un mauvis fonctionment de l’appareil.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
Sous la rѐ glementation d’Industrie Canada, ce transmetteur radio ne peut fonctionner en
utilisant une antenne d’un type et un maximum (ou moins) gain approuvѐ es pour l’ѐ metteur