Setup Guide

Beam Brush — Instructions for Use
SAVE THESE INSTRUCTIONS. PLEASE READ ALL INSTRUCTIONS BEFORE USE.
FCC Statement
This device is equipped with Transmitter Module FCC ID: O7P-4343.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
The Beam Brush’s wireless operation is safe and complies to RF Exposure requirements. This
equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
Any unauthorized modification to the devices included in this Beam product could void the
user’s authority to operate the product.
This device with transmitter module has been tested to SAR and complies with FCC exposure
requirements for portable devices. SAR testing has been done at a distance of 0mm from the
body.
Industry Canada Statement
This device contains Transmitter Module IC: 10147A-4343.
Cet appareil contient le module émetteur IC : 10147A-4343.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of the device.