User Manual

breakdowns & solutions
8
If there is a problem, this is shown on the displays.
Breakdown code Cause Solution
E1/E2 The voltage is too high or too low. Have your connection checked by an electrician.
E3/E4
The temperature of the glass plate sensor
is too high.
Allow the glass plate to cool down and then switch on the induction
hob again.
E5/E6 The induction hob has overheated. Switch off the induction hob and allow the cooking zones to cool down.
F3/F4/F5/F6/F7/F8 The temperature sensor is defective. Contact the Inventum service department.
F9/FA/FC/FD IGBT sensor is defective. Contact the Inventum service department.
Breakdown (code) Cause What to do
The induction hob does not
do anything when the plug
isinserted in the socket.
No power supply. Check that the plug is properly inserted in the socket
andthat there is power on the socket.
The display switches on,
butthe induction hob
doesnotheat up.
The induction hob is too hot. The ambient temperature can be too high.
Check if theairopenings are blocked.
The induction hob stops
all ofa sudden during use
andthedisplay shows
.
An unsuitable pan is being used.
Use a pan suitable for induction with the correct diameter
(minimum Ø 12, 14 or 16 cm, depending on the cooking zone
Ø 16, 18 or 21 cm).
The diameter of the pan used
istoo small.
A cooking zone switches off
automatically and the display
shows [ H ].
The maximum cooking time
hasbeen reached.
Switch on the cooking zone again.
The glass plate is cracked.
Hazard! Switch off the power supply and
remove the plug of the appliance. Contact the
Inventum service department.
English
• 31