Operation Manual

FAULTCODE DESCRIPTION CHECK
Display code
F5
Inadequate water supply • Check whether the tap is fully open and there is nothing blocking the water
mains.
• Close the tap, remove the input hose and check whether it is clogged.
• Start the dishwasher again. Contact the service department of Inventum
when the error remains.
F3
Water supply is not stopping. • Close the tap.
• Contact the service department of Inventum.
F2
The waste water can not be
discharged.
• The water discharge hose is
clogged.
• The filters might be clogged.
• Turn the dishwasher off. Reset the dishwasher’s program and check the
filters and the discharge hose. Restart the dishwasher.
• Contact the service department of Inventum when the error remains.
F8
The water temperature is not
correct. Heating defect.
• Contact the service department of Inventum.
F1
Safety is activated against water
overflow.
• Turn off the dishwasher and close the tap.
• Contact the service department of Inventum.
FE Faulty electronics. • Contact the service department of Inventum.
F7 Overheating error. • Contact the service department of Inventum.
F9 Position of the distributor error. • Contact the service department of Inventum.
F6 Faulty heat sensor. • Contact the service department of Inventum.
troubleshooting
7
40 • English