Operation Manual

cleaning & maintenance
6
Before cleaning the appliance set the thermostat to OFF and always unplug the appliance.
Clean the interior of the appliance. Use warm water and a neutral detergent to prevent any bad smells occurring. After cleaning, rinse
the interior with clean water and rub dry. Leave the appliance to dry for 1 to 2 hours. Simply remove the shelves, drawer and door
compartments to clean them by hand. Do not clean the interior accessories in the dishwasher.
Clean the outside of the appliance and the gasket with a soft moist cloth.
REPLACING THE BULB
When replacing the bulb, proceed as follows:
• Unplug the appliance from the mains.
• Remove the lamp cover.
• First check if the bulb is fully screwed in.
• If the bulb is defective, replace it with a bulb of the same type: maximum 10 Watt, socket E14. This kind is widely available.
• Replace the cover.
• Plug the appliance back into the mains.
troubleshooting
7
Problem Cause Solution
Appliance is not functioning;
light does not work
Appliance is not plugged in Plug the appliance in the socket
Temperature inside the
larder is too high or too low
Thermostat has been set
incorrectly
Set the thermostat correctly
Air circulation vents are blocked Clean the ventilation openings
Appliance is excessively noisy Has the appliance been
installed correctly?
Check the installation
Are the pipes at the back
touching or vibrating?
Check it and move the appliance forwards
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
18 • English