Operation Manual

Before cleaning the larder always unplug the appliance.
Clean the interior of the appliance. Use warm water and
a neutral detergent to prevent any bad smells occurring.
After cleaning, rinse the interior with clean water and rub
dry. Leave the appliance to dry for 1 to 2 hours. Simply
remove the shelves, drawer and door compartments to
clean them by hand. Do not clean the interior accessories
in the dishwasher.
Clean the outside of the larder and the gasket with a soft
moist cloth.
We recommend that you dus the back of the appliance
with a cloth or vacuum cleaner once a year in order to
maintain a good output and low energy consumption.
Defrosting of the larder compartment is completely
automatic. Droplets of water on the rear wall of the larder
compartment indicate that the periodic automatic defrost
cycle is in progress. The defrost water is automatically
routed to a drain outlet and into a container from which it
evaporates.
REPLACING THE BULB
When replacing the bulb, proceed as follows:
• Unplug the appliance from the mains.
• Remove the lamp cover by unscrewing the screw and
pull the lamp cover towards you.
• First check if the bulb is fully screwed in.
• If the bulb is defective, replace it with a bulb of the same
type: maximum 10 Watt, socket E14. This kind is widely
available.
• Replace the cover and the screw.
• Plug the appliance back into the mains.
Problem Cause Solution
Appliance is not
functioning;
light does not
work
Aplliance is not
plugged in
Plug the
appliance in the
socket
Temperature
inside the
larder is too high
or too low
Thermostat has
been set
incorrectly
Set the
thermostat
correctly
Air
circulation
vents are
blocked
Clean the
ventilation
openings
Water is running
out of the
larder
Drain outlet is
blocked
Clear the drain
outlet with a
skewer
13
5 | CLEANING & MAINTENANCE
6 | TROUBLESHOOTING
Problem Cause Solution
Appliance is
excessively noisy
Has the
appliance been
installed
correctly?
Check the
installation
Are the pipes
at the back
touching or
vibrating?
Check it and
move the
appliance
forwards
The inside light
is not working
Lamp is
defective
Replace the bulb
following the
instructions
Note: gurgling and hissing noises due to expansion in the
refrigerant circuit are normal.
7 | REVERSING THE DOOR OPENING
It is possible to change the door opening from either the
left or the right side. The appliance is delivered with the
door opening from the left side. To change the opening
direction, please follow these instructions.
Note: Before reversing the door swing, unplug the
appliance from the mains.
• Remove the screws at the back, holding the top panel
to the appliance.
• Lift the top panel at the backside and remove it.