User's Manual
User Manual CloudBoxx Mini
- Page 1 of 2 -
1 Introduction
The INVERS Keyholder is an optional accessory, that can be used to monitor the presence of the vehicle
key and/or up to two fuel cards.
INVERS Keyholder is compatible with INVERS CloudBoxx only.
Please note that the Keyholder must be installed into a vehicle only by qualified
staff!
The Keyholder is designed to be used only with INVERS Hardware.
2 Technical data
Supply Voltage
12V VDC (supplied from the CloudBoxx)
Frequencies & max. power
13.56MHz :57.74 dBμV/m
3 Installation advice
• All components and cables must be fixed in such a way that under no circumstances may
they block moving parts of the vehicle (pedals, wheels...).
• Connect the cable of the keyholder to the keyholder port of the CloudBoxx.
• Install the keyholder in a way that the driver cannot be distracted by the LEDs. The
recommended installation position is in the gloves compartment.
• For testing purposes, the Cloudboxx provides audible feedback when detecting or lossing
a paired RFID tag. To prevent the driver to be distracted, this feedback must be deactivated.
• When pairing more than one card with RFID sticker, choose different sticker positions for
each card (i.e. one sticker next to the card edge and one in the center)