Operation Manual
16
FINDING AND STORING THE CHANNELS– terreStrial
Once the channel search starts, a progress bar and list of channels found will be displayed. At any time, you may
stop the search by pressing the Exit key on the remote control. After the channel search is completed, press the
“Green” function key on the remote control to save the channel list and exit.
MANUAL CHANNEL SEARCH – terreStrial MODel
The manual channel search allows you to make a channel
search with known search parameters. The process is the
same as in the automatic channel search, described in
the previous section.
Channel
Use this option to select which TV channel to scan.
Auto modes
Use this option to set the FFT and Guard Interval. If you
choose manual, you can set specic values for the FFT
and Guard Interval modulation parameters.
Signal strength and signal quality bars
Thanks to two bar meters bar meters, the user can
measure the strength and quality of the incoming signal to
the receiver. These two meters can be used to adjust and
ne-tune of the antenna position. The antenna has to be adjusted to have maximum possible signal strength and
signal quality.
Basic Operation
PROGRAM NAVIGATION
You can enter the channel number with the numeric keys on your remote control.•
You can use the directional keys “Up” and “Down” on your remote control or on the front panel of the •
receiver.
You can use the P+ and P- keys on your remote control•
Scroll through the program list by pressing the “TV” key, select with the navigation key “Up” or ”Down” •
the program list, and conrm the channel selection with “OK” key.
VOLUME CONTROL
1. Press the V-/V+ key to adjust the audio volume.
2. Press the “MUTE” key to stop the audio temporarily.
Note: The mute function remains set while you switch channels.