User manual

15
En
Tap on “ Save ” at the bottom to save the new
created or modified TP list. If your SatPal™
Controller is connected to the antenna system
aligned to the satellite for what the TP list has
been created you will see immediately a signal
level, see Figure 21: New created TP list.
Figure 21: New created TP list
A selected TP will be marked with a check and is
listed at the bottom field, see Figure 20: Created
TP list.
Figure 20: Created TP list
Hint: A transponder list can include several TPs
assigned to different satellites, or all desired TPs
assigned to one UB, or the same TP assigned to
several different UBs. To avoid malfunctions you
should not create TP lists with different LNB types
(e.g. Universal + dCSS in the same TP list). You
also should not mix dynamic mode and static
mode configurations in one TP list.
By tapping on “ Remove ” at a selected
transponder the concerned TP will be removed of
the TP list, see Figure 20: Created TP list.