User manual

28
Tap on a particular UB row below the section
“ Output ” to change the particular UB
configuration. See Figure 44: Configuration
User Band, LNB.
Figure 44: Configuration User Band, LNB
At this section you can change via scrolling wheels
the protocols supported by the UB (Unicable™
(EN50494), Unicable II™ (EN50494+EN50607) as
well as its frequency and bandwidth.
By tapping “ Save ” at the bottom the changes
will be saved.
To disable a UB swipe the row of the required UB
to the right and tap on “ Disable ”, see Figure 45:
Disable, Enable UB, LNB.
Figure 45: Disable, Enable UB, LNB
To enable a UB again, do it vice versa by tapping
on “ Enable ”.
Home » Unicable II™ toolbox » upper
rectangle » configuration » Advanced
options
By tapping on “ Advanced options ”, you can
set further parameters like LO-frequencies or the
start-up mode, depend on connected device.
Afterwards tap on “ Save Configuration ” to
save changes.
By tapping on “ Commit changes ” the
configuration will be uploaded to the connected
device.