User manual

31
En
Unicable II™ diagnostic
Home » Unicable II™ toolbox »
“upper rectangle” » Diagnostic
After tapping on “Unicable II™ toolbox ” followed
by tapping on the “ upper rectangle ” of connected
device tap on “ Diagnostic ”.
At this section you have diagnostic tools available
to see the occupied spectrum and to get detailed
graphical information about temperature, resets and
occupied UB’s of a connected Unicable II™ device.
See Figure 51: Diagnostic for the Diagnostic
entry screen.
Figure 51: Diagnostic
To disable a UB swipe the row of the required UB
to the right and tap on “
Disable ”, see Figure 50:
Disable, Enable UB, MSW.
Figure 50: Disable, Enable UB, MSW
To enable a UB again, do it vice versa by tapping
on “ Enable ”.
Afterwards tap on “ Save Configuration ” to
save changes.
By tapping on “ Commit changes ” the
configuration will be uploaded to the connected
device.