User manual

7
EnEn
1. LNB/Switch (DC Out) – F-type
Connect to the LNB/ Multiswitch to be setup/programmed.
2. Receiver (DC IN, RF Loop) – F-type
Power supply (10 V ~ 20 V/13 W max.) from a receiver, a power inserter or a power supply.
3. Status LED
▪ Blinking white: communication with LNB/Multiswitch
▪ Steady read: configuration of connected dCSS device is not the same as
configuration stored in the SatPal™ Controller (standalone mode)
4. Bluetooth connection status LED:
▪ Blinking blue: not connected
▪ Steady blue: connected
5. Signal Strength and Quality LED bars
Indicate signal strength and quality in standalone mode, see Figure 2: Signal Strength
Figure 2: Signal Strength
6. User Button
User button function usable for standalone mode can be configured with the SatPal™ application.
7. PC (Data only) – micro USB
Connect the long USB cable to a PC to use the SatPal™ Controller with the Unicable II™
Programmer PC application (not for powering the SatPal™ Controller).
8. DC in – micro USB
Connect the short USB cable to a power bank or an AC/DC adapter to supply the SatPal™
Controller (5 V ~ 6 V/13 W max.).
9. Power Status LED
▪ Orange: power supply not sufficient for connected device
▪ Green: power supply sufficient to power connected device