User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 Wizard & Main Interface
- 4 Camera Management
- 5 Live Preview Introduction
- 6 PTZ
- 7 Record & Disk Management
- 8 Playback & Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Compatible Device List
Device Management
NVR User Manual
77
www.invidtech.com
11 Device Management
11.1 Network Configuration
11.1.1 TCP/IPv4 Configuration
IP Address Settings
Click StartSettingsNetworkTCP/IPv4 to go to the following interface. Check “Obtain an
IP address automatically” and “Obtain DNS automatically” to get the IP address and DNS
automatically, or manually input IP address, subnet mask, gateway, preferred DNS and
alternate DNS. Click “Apply” to save the settings.
Note:
Internal Ethernet Port
If you use the NVR with the PoE network ports, the online state of the internal ethernet port
will be shown on the interface. Refer to the picture below.
The internal ethernet port is the port which connects all the PoE ports with the NVR system.
The PoE ports are available if the internal ethernet port is online; if it is offline, all the PoE
ports will be unavailable, may be the internal ethernet port is broken. The IP address and subnet