Use and Care Manual

Anti-Slip Solutions, LLC
2020
**IMPORTANT: Read all instructions before beginning application process***
InvisaTread Detailed Application Instructions
Tools Required:
A. Trigger Sprayer, Microfiber Spreader or Garden style Pump Sprayer
a. (Pump sprayer recommended for larger areas)
B. Two, 5 gallon pails/buckets – clean
C. Sponge Mop or Wet-Dry Vacuum/Extraction Tool (recommended)
D. Deck Brush (for pre-application cleaning, if needed)
**PRE-APPLICATION TESTING***
Utilize steps 1 – 4 below on a small hidden area, or extra tile to determine
dwell time for your particular surface and desired traction. In general,
longer dwell time equals higher traction. Start with 6 minutes of dwell
and work up to no more than 16 minutes. Occasionally, 2 applications
are needed to increase traction to desired levels, rinse/extract 1st application
& repeat steps 2-4.
Pre-application set-up
• In 1st 5 gallon bucket, mix 6 oz. Traction Wash per gallon of water,
a 1:20 dilution. Use a higher concentration (up to 12 oz/gal) if very
dirty or greasy. Set aside remaining solution for RINSE step.
• Fill sprayer (or 2
nd
bucket, if spreading instead of spraying) with
1 gallon of InvisaTread per 400 sqft. Do not dilute InvisaTread.
Do not mix chemicals.
Application Process
Step 1: CLEAN. Clean the floor very well with the Traction Wash solution.
If necessary, use the deck brush to scrub the tile & grout for very dirty floors. Rinse the floor with clean water and
dry. Use a wet dry vacuum or extraction tool, if available. It is ok to leave the grout joints wet or damp.
Step 2: APPLY. Spray or spread the InvisaTread onto the area to be treated. Use a liberal amount of product. Coverage
should be about 400 sq. ft per gallon.
Step 3: DWELL. Allow InvisaTread to dwell for 6 – 16 min (exact time shall be determined by your pre-application testing).
Keep surface saturated with product during the entire dwell time. DO NOT allow to dry out, puddle or run off.
Apply more InvisaTread, as needed.
Step 4: RINSE. After dwell time has elapsed pour 1:20 Traction Wash dilution onto the tile and scrub grout joints with
brush to break up residue. Extract surface. Rinse a 2nd time with clean water and then extract surface. Surface
is ready for immediate use.
***Test traction by wetting the surface with clean water and trying to slide foot. If
more traction is desired, do a 2nd application, repeat steps 2 - 4.***
Clean regularly with Traction Wash™ @ 1:32 dilution, to maintain your enhanced Coefficient Of Friction (COF).
Troubleshooting - if necessary
After grout has completely dried out you might notice some white residue form in a few spots over the next few days. This
is simply a salt residue left over after application; it is not harmful and will be removed with regular cleaning over the next
few days. To remove right away, scrub with 1:4 dilution of vinegar to water, or 1:32 dilution of TractionWash to water.
NOTE: This does not occur on every application or every type of grout.
Contact customer service at 888-842-3356 with any questions.
Company Profile:
Surface Solutions, LLC
Industry:
Surface Engineering
Consulting
Slip Resistant Treatments
Anti-Graffiti Treatments
Website: www.InvisaTread.com
www.TotalSurfaceSolution.com
Corporate Address:
515 Valley St.
Suite 130
Maplewood, NJ 07040
Contact:
[e-mail]
888-842-3356