Instructions / Assembly

ManualsBrandsInvisiDoor ManualsBifold Doors60 in. x 84 in. Unfinished Maple 6-Shelf Bookcase Bi-Fold Door

nvisi

oor

Required Tools:

Cordless drill/screwdriver

Drill bits – 3/32” and 5/8”

Level

Hack saw

Preparation

● The Bifold Bookcase will be mounted in front of a doorway. Verify that the

wall is plumb. If it is not, adjustments may need to be made for correct

appearance and operation. It is not necessary to remove trim from the door to

be able to install the bookcase.

● The weight of the bookcase will be mounted on a baseplate and track

that are designed to be mounted directly to the  oor with the included wood

screws. Verify that the  oor has adequate support for weight of the bookcase

and its contents and appropriate mounting area for the screws.

● It is recommended that you test mount the hardware and install the

bookcase prior to applying stain and  nish coat. This will eliminate the chance

of damaging the  nished product during the process of mounting the hardware

and making adjustments.

Installation Instructions:

Bi-Fold Bookcase

Summary of content (4 pages)

PAGE 1
Invisi Door TM Bi-Fold Bookcase Installation Instructions: Preparation The Bifold Bookcase will be mounted in front of a doorway. Verify that the wall is plumb. If it is not, adjustments may need to be made for correct appearance and operation. It is not necessary to remove trim from the door to be able to install the bookcase. ● The weight of the bookcase will be mounted on a baseplate and track that are designed to be mounted directly to the floor with the included wood screws.
PAGE 2
Install Hardware to Floor Begin by deciding where the door will mount in relation to the opening. The bookcase can pivot on the left or right. All diagrams are shown with pivoting hardware mounted on the right side of bookcase. The baseplate and track will both be mounted to the floor centered 5-1/2” away from the wall. Be sure that the track and baseplate are in a straight line that is parallel to the wall.
PAGE 3
(Fig.#5) Install Hardware to Top of Bookcase Fasten the plate to the top of the pivoting side of the bookcase as shown (Fig.#5). 4-1/2” Wood 2x4 1-3/4” Fasten the plate with roller to the top of the rolling side of the bookcase as shown (Fig.#6). Wood 2x4 4-1/2” (Fig.#6) Attach Hardware to Valance Drill a 5/8” hole through the valance at the location shown. Fasten plate to the bottom of the valance on the pivoting side of the bookcase as shown.
PAGE 4
Install Bookcase Install washers onto the floor mounted baseplate. This method allows you to make adjustments to make sure that bookcase is level from side to side. Typically, a total of 6 washers will be used. The bronze bearing washer is intended to be the top washer to keep the bookcase pivoting freely. Move the bookcase into place with the plate of the pivoting side set onto the floor-mounted base plate and the wheel set onto the floor-mounted track. (Fig.