User's Manual

26Chapter2:GettingStarted989803173791 Rev 0.6
matchthesettingassignedtothemonitor;seeNetworkMenuinChapter3formonitorsetup
details.
Thewirelessnetworkforthemoduleisindicatedbyitsilluminatedicon,whilethecurrently
assignednetworkforthemonitorisindicatedbythenetworkbuttononthe
displaypanel.
CAUTION
Forsystemcommunications,themonitorandmodulemusthavethesamenetworksetting.
Changing the Module Network Setting
Thewirelessnetworkforthemoduleischangedviaitsnetwork
selectionbutton,locatedbeneath theoverlay,inthefrontupper
leftcornerofthedevice.(Aslightbumpcanbefeltwhenyoupassa
fingeroverthebutton.)
Whenselectinganetworkforthemodule,placethemoduleon
a
flatsteadysurface,orholditasshownintheillustration ,anduse
yourthumbtopressthenetworkselectionbutton.
Beforestartingtheprocedure,takenoteoftheseconventionsthat
areusedtoexplaintheprocess:
•Intheprocedurebelow,thefollowingsymbolsareusedtoconveythestate
ofthenetwork
icononawirelessmodule.
• Intheprocedurebelow,thefollowingillustrationsareusedtocon veyactionsconcerning
theuseofthenetworkselectionbutton:
Iconilluminated Iconflashing
Pressthe
button
Releasethe
button
Pressandhold
thebutton
Repeatas
desired