User's Manual

28Chapter2:GettingStarted989803173791 Rev 0.6
4Setthenetworkofthemoduletothesamenetworkasthemonitor
(seeStep1).Enterthenetworkchangemode.Afterthecurrent
networkiconhasbeenilluminated(andwithin15secondsfrom
modulepower‐up)pressandholdthenetworkselectionbutton
until
thecurrentnetworkiconbeginsflashingrapidly.Thenrelease
thenetworkselectionbutton.
NOTE
Ifthenetworkchangesequenceisnotstartedwithin15seconds
afterthemodulehasbeenturnedon,anetworkchangewillnotbe
allowed.Youmustcyclemodulepowerandrestartthesequence.
5Changingthenetwork,pressthebuttonagainuntiltheicon stops
flashing,thenreleasethebutton.Whenyoudothis,thenext
networkiconinthesequencewillblinkrapidly.(Inotherwords,if
themodulewasoriginallyusingnetwork“C,”
nowthe“D”iconwill
beflashing.)Repeatthissequenceofpressingandreleasingthe
buttonuntiltheiconofthenetworkyoupreferisrapidlyflashing.If
youpassthedesirednetwork,simplycontinuepressingand
releasingthebuttonuntilthedesirednetworkisflashingagain.
Step Action