User's Manual

66Chapter5:Workflow989803173791 Rev 0.6
NOTES
•Toestablishpatientmonitoring,theEssentialmustbecommunicatingonthesamenetwork
asthemoduleandattachedtothepatient.
• Monitorsettings(forexample,patientcategory,alarmlimits,etc.)donottransferbetween
monitoringsystems,andalarmbehaviorremainslinkedtothealarmlimitsettingsandthe
detectednumerics.
Workflow Management
Thefollowingdiagramsill ustratetypicalandalternateworkflowobjectiveswhenusingthe
EssentialasastandalonedeviceorwhenusingittogetherwithcompatibleInvivoMRImonitors.
NOTE
Thenetworksettingsandgroupingsusedbelowaregivenasexamplesonly;yourselectionsmay
differ.However,thenetworkconventions(A‐Eor1‐5)aswellasthegroupingofthesettings
(networkAversusB,1versus2,etc)shouldbeobserved.
WorkflowwhenusingtheEssentialasastandalonemonitorwithoneWSpO
2
module:
•Apatient,anMRinductionroom,anMRsystemroomandanMRrecoveryroom.
– TheEssentialandtheWSpO2modulearesettonetworkAornetwork1,depending
uponthemoduletype(ExpressionorPrecess‐Blueversion).
Step Action
1PrepthepatientintheMRinductionroom.
2Turnon
theEssentialandtheWSpO
2
module.Botharesetto
networkA(or1).
3Verifysufficientpowerandgoodcommunications.
4ApplytheSpO
2
sensortothepatient.