User's Manual

989803173791 Rev 0.6Chapter5:Workflow 71
10 Inthecontrolroom,onthePrecessCRDdisplaypanel,pressthe
MONITORSETUPkey.TurnthecontrolknobtoNETWORK,pressthe
knobandselectNetwork2.
11 OntheEssentialdisplaypanel,presstheNetworkbuttonthen
selectNetwork1.
NOTE
TouchtheAlarmsPausebuttontotemporarilydisablethealarm
functions.
12 VerifysufficientpowerandgoodcommunicationsfortheWSpO
2

module.(TheECGmodulewillnotbeusedandcannotnotbe
checkedatthispoint.)
13 TransportthecurrentpatientwiththeEssential,theWSpO
2

moduleandtheECGmoduleintotheMRrecoveryroom.
14 Ifneeded,transitionthecurrentpatientintheMRrecoveryroom
tobedsidemonitoring.TaketheEssentialtheWSpO
2
moduleand
theECGmoduleintotheMR inductionroomforthenextpatient.
15 Scannewthepatient,usingthePrecessCRDinthecontrolroom.