Installation Guide

H
andle with care, ensure not to drop or step on the device.
Perform occassional cleaning to eliminate a build-up of dust, dirt, oil and residual grime.
Do not use harsh or abrasive chemicals to clean the surface of the sensor, as this may cause permanent damage to the device.
Do not use sandpaper, steel wool, scouring pads, chlorine, ammonia, bleach, or any inappropriate products for cleaning.
Device Handling Do's
Do not install in areas with direct sunlight, high levels of humidity, extreme dust or flammable vapours.
Do not allow magnetic objects to come in close contact to any device.
Do not install near any heating elements or equipment.
Do not attempt to open or disassemble the device, as this will void the product warranty.
Do not deploy for any use other than its intended purpose.
Do not insert anything other than the correct fitting USB plug into the USB port, located at the bottom of the device.
Device Handling Don'ts
The component that will require most frequent cleaning is the sensor, as it experiences the most contact. The cleaning should be performed
with care and attention, as improper cleaning may damage the sensor or surrounding components.
Follow the steps below for proper sensor cleaning procedure:
1. Lightly moisten a new cotton swab or lint free polishing cloth with water or isopropyl alcohol.
2. Gently wipe the surface of the sensor with the moistened cotton swab or cloth.
3. Finish wiping the sensor again with a dry cotton swab or cloth.
Device Cleaning
W
ARNING
5
C
opyright 2019
INVIXIUM