Installation Instructions

OnePOD Wearables

Sensor Tray - DBD216

Remove the the watch bands.

Slide the watch band pins in to

release the watch bands.

Optional:

If installing the 42mm version of the

watch. Place the trim piece onto the

cradle.

Reinstall both watch bands.

Place the watch onto the cradle.

Orient the band clip so that the at

side of the clip will sit along the top

side of the band.

Flat Side

Slide the clip over the band from the side

with the pin. Repeat for the other band.

Place the 2 clamp pieces around the

watch. Make sure that the tabs on

the clamps align into the slots on the

underside of the cradle.

PAGE 1
Slide the watch band pins in to release the watch bands. 2 Remove the the watch bands. 3 Orient the band clip so that the flat side of the clip will sit along the top side of the band. Flat Side OnePOD Wearables Sensor Tray - DBD216 Slide the clip over the band from the side with the pin. Repeat for the other band. 4 Reinstall both watch bands. 2 1 5 Optional: If installing the 42mm version of the watch. Place the trim piece onto the cradle. 6 Place the watch onto the cradle.
PAGE 2
8 12 Secure the clamps to the cradle using the 4 provided screws. Tighten fully. Plug the sensor cable from a previously installed OnePOD stand into the bottom of the sensor. 9 13 Insert the watch band through the hoop on the stem and under the sensor. Place the sensor onto the stand. 10 Connect the wearable sensor to the OnePOD sensor. PMN: ONEPOD WEARABLE GALAXY SENSOR FCC ID: 2AFR8F1748A IC: 23313-F1748A 11 Use the 2 provided screws to secure the 2 sensors together..