Instruction Manual
Table Of Contents
- Glossary of terms
- 1. This manual
- 2. Safety
- 3. Get to know SBV System Series
- 4. Functioning principles
- 4.1 Sensor functioning principles
- 4.2 Detection fields
- 4.3 Safety working modes and safety functions
- 4.4 Safety working mode: Both (default)
- 4.5 Safety working mode: Always access detection
- 4.6 Safety working mode: Always restart prevention
- 4.7 Restart prevention function: static object detection option
- 4.8 Features of the restart prevention function
- 4.9 Muting
- 4.10 Anti-tampering functions: anti-rotation around axes
- 4.11 Anti-tampering functions: anti-masking
- 5. Sensor position
- 6. Installation and use procedures
- 7. Maintenance and troubleshooting
- 8. Technical references
- 9. Appendix
22
SBV System Series| Instruction manual v1.2 DEC 2021 |SAF-UM-SBVBus-en-v1.2|© 2021 Inxpect SpA
3. Get to know SBV System Series
3.4.3 Access
The application can be downloaded free of charge at www.inxpect.com/industrial/tools.
Some functions are password protected. The admin password can be set through the application and then saved
on the control unit. The available functions according to access type are presented as follows:
Available functions Access type
l Display the system status (Dashboard)
l Display the sensors configuration (Configuration)
l Restore factory default settings, if not using Ethernet connection (Settings > General)
l Back up the configuration (Settings > General)
without password
l Synchronize more control units (Settings > Multi-control unit synchronization)
l Validate the system (Validation)
l Restore factory default settings, if using Ethernet connection (Settings > General)
l Download the system log and display reports (Settings > Activity History)
l Check the current checksum for each dynamic configuration (Settings >
Configuration checksum)
l Configure the system (Configuration)
l Load a configuration (Settings > General)
l Change the admin password (Settings > Account)
l Update the firmware (Settings > General)
l Show and change the network parameters - if available (Settings > Network
Parameters)
l Show and change the Modbus parameters - if available (Settings > Modbus
Parameters)
l Show and change the Fieldbus parameters - if available (Settings > Fieldbus
Parameters)
with password
3.4.4 Main menu
Page Function
Dashboard Display main information on the configured system.
Note: the messages shown are those in the log file. To know the meaning of the
messages, see the chapters on logs in "Maintenance and troubleshooting" on
page64.
Configuration Define the monitored area.
Configure the sensors and the detection fields.
Define the dynamic configurations
Validation Start the validation procedure.
Note: the messages shown are those in the log file. To know the meaning of the
messages, see the chapters on logs in "Maintenance and troubleshooting" on
page64.
Settings Configure the sensors.
Choose the detection fields dependency.
Enable the anti-tampering functions.
Synchronize more control units.
Configure the inputs and outputs function.
Configure, show and change the network parameters (if available).
Configure, show and change the Modbus parameters (if available).
Configure, show and change the Fieldbus parameters (if available).
Update the firmware.
Perform the configuration backup and load a configuration.
Download the log.
Other general functions.
REFRESH
CONFIGURATION
Refresh configuration or ignore unsaved changes.