Installation Manual

The UT32 thermostat can control up to three Zone One dampers wired in parallel.

UT32 TOUCHSCREEN THERMOSTAT

THERMOSTAT SUB BASE

IF THERMOSTAT IS BATTERY POWERED ONLY,

24VAC COMMON IS NOT REQUIRED

SC S1

O/B

AUX AUX

Y1 Y2 W1

www.jacksonsystems.com

WIRE

ACCESS

HOLE

BATTERY

COMPARTMENT

MOUNTING HOLES

MOUNTING

HOLE

D-Z1-XX & D-Z1-XXXX

10 VA

PAGE 1
D-Z1-XX & D-Z1-XXXX UT32 TOUCHSCREEN THERMOSTAT BATTERY COMPARTMENT www.jacksonsystems.com WIRE ACCESS HOLE MOUNTING HOLES MOUNTING HOLES W2 S2 SC S1 AUX AUX O/B MOUNTING HOLE Y1 Y2 W1 G R C 10 VA THERMOSTAT SUB BASE IF THERMOSTAT IS BATTERY POWERED ONLY, 24VAC COMMON IS NOT REQUIRED 10 VA The UT32 thermostat can control up to three Zone One dampers wired in parallel.
PAGE 2
D-Z1-XX & D-Z1-XXXX Thermostat Setup The Zone One, two position, stand-alone damper assembly can be controlled with the UT32 Universal Touchscreen Thermostat. Refer to the Installer and User Manuals included with the thermostat for proper configuration based on application requirements. It is highly recommended that the thermostat be placed in the Auto Changeover mode of operation for proper damper control of both heating and cooling calls.