Product Overview

ESP 6 Zone
Zone Control Panel
ZP6-ESP
The ZP6-ESP is a 6 zone panel that integrates our award winning ESP technology to completely
eliminate the need to install a bypass damper. This 4H/2C zone panel comes with a static pressure
sensor. The system works like any standard zone control system with one exception; a static pressure
sensor continuously monitors the system static pressure. If the static pressure goes above setpoint, the
ESP panel will power the selected non-calling zone dampers open just enough to relieve the excess
pressure. Tests indicate that bleeding a small amount of conditioned air for a short time into non-calling
zones has little to no impact on the zone temperature.
The panel can be used with single-stage, multi-stage, heat pump or dual fuel equipment. Programmable
LCD and slide switch conguration makes setup quick and easy. A wide range of control options provide
ultimate application exibility including adjustable high/low limits, adjustable high/low balance point,
stage timing, capacity control and priority cooling control.
Features and Benets:
• 6 zones expandable up to 12 (using ESP
expansion panel)
• Auto changeover
• Cooling priority or majority wins
• Twenty minute time share option
• Optional night thermostat
• Humidication/Dehumidication pass-throughs
• Staging by zone thermostat or built in upstage
timer
• 2nd stage capacity control option
• Purge cycle option
• Works with 2 or 3 wire zone dampers*
• Adjustable high and low limit
• Adjustable high and low balance point
Warranty: 10 years
NO BYPASS REQUIRED!
Specications:Specications:
Construction
Aluminum enclosure with snap-on panel cover
Dimensions
13.50” Height x 11.00” Width x 2.00” Depth
Operating Temperature
-40° F to 150° F
Adjustable Discharge Air Limits
Low Limit (40° F to 58° F)
High Limit (100° F to 175° F)
Outdoor Balance Points
Low Balance Point (0° F to 50° F)
High Balance Point (55° F to 70° F)
Purge Cycle
O󰀨 or 1 minute
Fan Mode
All zones or by zone thermostat
Also available
as kit including:
- Zone Panel
- 2 Duct Temperature Sensors
- Static Pressure Sensor
- 75VA Transformer
*For ESP functionality, 3-wire MD dampers and static pressure sensor must be used
Static pressure sensor &
panel cover included