Install Instructions

The ZP6 comes

ZP6 and all

ZP6 Six Zone Forced Air Zoning System

The ZP6 is a residential and light commercial forced air zone control system that allows a single HVAC unit to

have up to six separate zones. The system can be expanded to as many as 12 zones by adding 3-zone expansion

modules. Intuitive ﬁrmware allows the panel to be used with single stage, multi-stage, heat pump and dual fuel

equipment having up to 3 stages of heating and 2 stages of cooling. Standard heat / cool or heat pump

thermostats can be used with the ZP6 along with a choice of two or three-wire zone dampers.

PAGE 1
ZP6 Six Zone Forced Air Zoning System The ZP6 is a residential and light commercial forced air zone control system that allows a single HVAC unit to have up to six separate zones. The system can be expanded to as many as 12 zones by adding 3-zone expansion modules. Intuitive ﬁrmware allows the panel to be used with single stage, multi-stage, heat pump and dual fuel equipment having up to 3 stages of heating and 2 stages of cooling.
PAGE 2
1. 1. ZPA-DTS Mount the ZPA-DTS Discharge Temperature Sensor in the supply trunk. Mount the sensor out of the line of sight of the heat exchanger and cooling coils whenever possible and before any zone dampers. The ZPA-DTS sensor has a resistance value of 10,000 Ohms @ 77° F. ZPA-OTS (For dual fuel applications) Mount the ZPA-OTS Outdoor Temperature Sensor inside the outdoor unit where it will not be directly exposed to sunlight, water, snow or ice.
PAGE 3
PAGE 4
High Limit (ZPA-DTS Sensor) - Adjustable from 100° to 175° F. High limit setpoint should be below safety limit setpoint of heating system. When limit is reached, fan continues to run but equipment is shut oﬀ or down-staged to prevent overheating. Low Limit (ZPA-DTS) - Adjustable from 40° to 58° F. Used to prevent coil from freezing. Allows fan to run but shuts oﬀ or down-stages equipment while activating a time delay to prevent short cycling.