Users Manual Part 2

2x2 Indoor & Outdoor Access Points Revision: A0-00
62
CONFIDENTIAL
16.1 General Network interface setup configuration for thick AP
The default IP address of the access point is set to 192.168.1.1. The user can change the current static IP address of
the device from this screen. DHCP client (DHCP client or DHCPv6 client) option is to get the dynamic IP address
from reachable DHCP server in the network. Once the protocol is set to DHCP client or DHCPv6 client, the device
will automatically get the IP address (IPv4 or IPv6) from the DHCP s erver.
Click on the “Edit” option in interface screen as shown in “Figure 39: Basic overview of the interface configuration
screen for thick AP”. A basic overview of the network interface setup configuration screen to switch network
protocol is given below:
Figure 40: Basic overview of the network interface setup configuration screen to switch protocol for thick AP
Follow the steps given below to switch network protocol:
Table 30: List of actions to switch network protocol for thick AP
Callout
Name
Description
1.
General Setup
Click on “General Setup” option
2.
Protocol
Select the protocol desired protocol from the dropdown list
(Static address/DHCP client/DHCPv6 client)
3.
Really switch protocol
Click on “Switch protocol” to confirm the protocol switch