Manualshelf

Users Manual Part 2

ManualsBrandsio ManualsElectronicsDual band 2X2 Outdoor Access Point (AP) with external antenna
11121314151617181920
2x2 Indoor & Outdoor Access Points Revision: A0-00
65
CONFIDENTIAL
16.1.2 DHCPv4 client configuration for thick AP
If the protocol is set to DHCPv4 client, the device will automatically get the IPv4 address from the DHCP server.
Refer “Figure 40: Basic overview of the network interface setup configuration screen to switch protocol for thick
AP” and set the protocol to DHCPv4 client.
Refer the figure below and switch the protocol to DHCPv4 client for thick AP:
Figure 42: Basic overview of network interface screen to set the protocol to DHCPv4 for thick AP
Follow the steps given below to set the protocol to DHCPv4 for thick AP:
Table 32: List of actions to set the protocol to DHCPv4 for thick AP
Callout
Name
Description
1.
Protocol
Set the protocol from the dropdown list (Static
address/DHCPv4 client/DHCPv6 client) to DHCPv4
2.
Really switch protocol
Click on “Switch protocol” to confirm the protocol switch
Click “Save” to save the general network setup configuration or click “Reset” to configure the same again.