Users Manual Part 2

2x2 Indoor & Outdoor Access Points Revision: A0-00
70
CONFIDENTIAL
16.2.2 2.4 GHz radio configuration
This screen provides the user with options to configure the 2.4 GHz radio parameters such as channel bandwidth,
respective channel or the channel selection process, and the power for the radio signal transmission. Refer the
“Figure 44: Basic overview of the wireless configuration screen for thick AP” and click on Add SSID/Radio
Configuration option (8) to configure 2.4 GHz radio parameters.
A basic overview of the 2.4 GHz radio configuration screen is given below:
Figure 46: Basic overview of the 2.4 GHz radio configuration screen
Follow the steps given below and for 2.4 GHz radio configuration of thick AP:
Table 36: List of actions for 2.4 GHz radio configuration of thick AP
Callout
Name
Description
1.
General Setup
Click on “General Setup” option
2.
Radio Status
Enable or disable the 2.4 GHz radio with this option
3.
Tx Power (dBm)
Enter the “Tx Power” value. The wireless radio signal will
be transmitted with the specified Tx power value. The user
can set the Tx power value from the range of 7 dBm to 19
dBm
4.
Mode
Select the radio operating mode from the dropdown list (802
11b/g/g+n). Channel width and channel list varies with