Users Manual Part 2

2x2 Indoor & Outdoor Access Points Revision: A0-00
52
CONFIDENTIAL
15.2 System log settings
If user wants to see the back-end logs or if user faces any issue, logs relevant to the AP’s application software are
populated in the Diagnostic/
System LogError! Reference source not found. screen for monitoring purpose. The
same can be uploaded to an external server and the configuration for the same is performed in this screen. Event
messages or corresponding messages will be sent to the logging server based on the configured log level.
A basic overview of the screen is given below:
Figure 30: Basic overview of the system general settings screen for thick AP
Follow the steps given below and configure the system general settings for the thick AP:
Table 22: List of actions to configure the system general settings for thick AP
Callout
Name
Description
1.
System
Click on “System” dropdown
2.
System
Click on “System” option
3.
Log Settings
Click on “Log Settings” option
4.
External system log
server
Enter the “External system log server” address. The system logs are
uploaded to the external server on regular interval if the external
server is specified with this option
5.
External system log
server port
Enter the “External system log server port” number
6.
Log output level
Select the “Log output level” from the dropdown list
(Debug/Info/Notice/Warning/Error/Critical/Alert/Emergency).
Categorization of the system logs is specified in the backend. The
selection of “Log output level” determines the type of logs to be
displayed in system log screen. The “Debug” option shows all of the
system logs. E.g.: If “Debug” is selected, all logs from debug to
emergency will be logged and if “Notice” is selected, logs from
Notice to Emergency will be logged
7.
Time sync/ NTP
Click on the check box and enable or disable the NTP client