Users Manual Part 2

Indoor & Outdoor Access Points Revision: A0-09
66
CONFIDENTIAL
16.1.1 Static IP configuration for thick AP
The default IP address of the access point is set to 192.168.1.1. User can change the default IP address with an
unused IP address. Refer “Figure 47: Basic overview of the network interface setup configuration screen to switch
protocol for thick AP” and set the protocol to static address.
Refer the figure below to provide the static address parameters:
Figure 48: Basic overview of static address parameters for general network interface setup for thick AP
Follow the steps given below to provide static address parameters for thick AP:
Table 34: List of actions to provide static address parameters for thick AP
Callout
Name
Description
1.
Protocol
The protocol is set to “”Static address”. Enter the following
parameters for the same
2. Protocol Selection
Set the static address protocol to IPv4/IPv6/IPv4 & IPv6.
Below parameters are shown with respect to IPv4 & IPv6
protocol selection
3.
IPv4 address
Enter the “IPv4 address”. This is a unique address of the
Hos t/Device eg.192.168.100.10
4.
IPv4 netmas k
Enter the “IPv4 netmask”. This specifies the number of bits
for network part and host part e.g.255.255.255.0