Manualshelf

Users Manual Part 2

ManualsBrandsio ManualsElectronicsDual band 4X4 lndoor Access Point (AP) with integrated antenna
21222324252627282930
Indoor & Outdoor Access Points Revision: A0-09
69
CONFIDENTIAL
16.1.3 DHCPv6 client configuration for thick AP
If the protocol is set to DHCPv6 client, the device will automatically get the IPv6 address from the DHCP server.
Refer “Figure 47: Basic overview of the network interface setup configuration screen to switch protocol for thick
AP” and set the protocol to DHCPv6 client.
Refer the figure below and switch the protocol to DHCPv6 client for thick AP:
Figure 50: Basic overview of network interface screen to set the protocol to DHCPv6 for thick AP
Follow the steps given below to set the protocol to DHCPv6 for thick AP:
Table 36: List of actions to set the protocol to DHCPv6 for thick AP
Callout
Name
Description
1.
Protocol
Set the protocol from the dropdown list (Static
address /DHCPv4 client/DHCPv6 client) to DHCPv6
2.
Really switch protocol
Click on “Switch protocol” to confirm the protocol switch
Click “Save” to save the general network setup configuration or click “Reset” to configure the same again.