Users Manual Part 3

Indoor & Outdoor Access Points Revision: A0-09
85
CONFIDENTIAL
16.5.1 Static/Active lease settings
Static leases are used to assign fixed IP addresses and symbolic hostnames to DHCP clients. They are also required
for non-dynamic interface configurations where only hosts with a corresponding lease are served. A basic overview
of the screen to configure a static lease is given below:
Figure 62: Basic overview of the screen to configure a static lease
Follow the steps given below to configure a static lease:
Table 48: List of actions to configure a static lease
Callout
Name
Description
1.
Network
Click on “Network” dropdown
2.
DHCP and DNS
Click on “DHCP and DNS” option
3. Add
Click on “Add” option to add a new static lease. The user
can add multiple static leases
4.
Host Name
Provide a unique name to the static lease for identification
5. MAC-Address
Click on the dropdown and select a MAC-address from the
list. The selected MAC-address identifies the host
6.
IPv4 Address
Click on the dropdown and select an IPv4-address from the
lis t. The selected IPv4-address is assigned to the host as a
fixed address
7.
IPv6-Suffix
Enter the IPv6-suffix for the host
Click “Save & Apply” to save the static lease or click “Reset” to configure the same again.
8.
Delete
Click on the “Delete” option to remove the respective static
lease
9.
Active DHCP Leases
Dis plays all active IPv4 leases in a listed form
10.
Active DHCPv6 Leases
Displays all active IPv6 leases in a listed form