GBC232A RS232 Serial Adapter QUICK INSTALLATION GUIDE version 1.
WELCOME Thank you for your purchase of the RS232 Serial Adapter. Featuring Bluetooth wireless technology, RS232 Serial Adapter creates virtual RS232 connections between your PCs and other RS232 peripherals. RS232 Serial Adapter is compatible with all Bluetooth V.2.0-certified and is backward compatible with v1.1/1.2 devices. You can connect your computers and RS232 devices 100 meters away without cables in your working environments. FEATURES Compatible with Bluetooth v2.
RS232 SERIAL ADAPTER Slide Switch Bluetooth LED DC Power Jack Mode LED Power LED Mode Button GETTING TO KNOW YOUR RS232 SERIAL ADAPTER 1). RS232 Connector: DTE - Connect to any DCE device (Master/such as a modem). DCE - Connect to any DTE device (Slave/such as a PC). 2). Mode Button: Push it to change operation between Configure/Data Mode and Reset function. 3). Apply power to Bluetooth RS232 Serial Adapter by using the power adapter accompanied. 4).
RS232 SERIAL ADAPTER INSTALLATION HARDWARE INSTALLATION : There are two kinds of RS232 devices in the market : DTE - Data Terminal Equipment (such as a PC). DCE - Data Communication Equipment (such as a Modem). Depending on what kind of the RS232 device your RS232 Serial adapter is going to connect, you can choose appropriate DTE or DCE RS232 Serial adapter to work with it. At DCE device side : Connect a DTE RS232 Serial Adapter to the remote DCE RS232 device (such as a Modem).
1. Configuring RS232 Serial Adapter on PC 1: Step 1: Connect a DCE RS232 Serial Adapter to COM1 Port of PC1. Apply power to it. Step 2: Push Mode Button until the MODE LED lights, then it enters Configuration Mode. Step 3: Launch RS232 Serial Adapter UtilityCable Replacement Config Tool.exe on PC1. Step 4: Select COM1 Port which RS232 Serial Adapter is connected. We assume it is the first time you are configuring this RS232 Serial Adapter, you can choose the default Baud Rate: 115200 Press Connect Button.
2. Configuring Serial Adapter on PC 2: Step 1: Connect a DCE Serial Adapter to COM1 Port of PC1. Apply power to it. Step 2: Push Mode Button until the MODE LED lights, then it enters Configuration Mode. Step 3: Launch Serial Adapter UtilityCable Replacement Config Tool.exe on PC2. Step 4: Select COM1 Port which Serial Adapter is connected. We assume it is the first time you are configuring this Serial Adapter, you can choose the default Baud Rate: 115200 Press Connect Button.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
