User's Manual
Table Of Contents
- _GoBack
- FCC Information
- User Notice
- Package Content
- About This Manual
- Chapter 1 - Introduction
- Overview
- Chapter 2 - Hardware Setup
- Chapter 3 - Operation
- Appendix
- Specification - DisplayPort Single View Secure KVM
- Specification - DisplayPort Dual View Secure KVM
- Specification - HDMI Single View Secure KVM
- Specification - HDMI Dual View Secure KVM
- Specification - DVI Single View Secure KVM
- Specification - DVI Dual View Secure KVM
- Limited Warranty
17
Hardware Setup
8. For security, do not use any USB CAC authentication device or other peripherals that adopt an
external power source.
9. Always use qualied monitor(s). Non-qualied monitors will be rejected.
10. Do not use wireless video transmitters or any docking device.
11. Do not connect any Thunderbolt device to IOGEAR Secure KVM Switch.
Secure Installation
1. Do not attempt to connect or install the following devices to the computers connected to IOGEAR
Secure KVM Switch:
• TEMPEST computers,
• Telecommunication equipment,
• Frame grabber video cards, or
• Special audio processing cards
2. Important safety information regarding the placement of this device is provided on page 25. Please
review it before proceeding.
3. Before installation, please make sure that the power sources to all connected devices are turned off.
You must unplug the power cords of any computers that have the Keyboard Power On function.
4. Hot-swapping of the console monitor is not allowed. Power off the Secure KVM Switch and the
monitor before changing the console monitor.
5. A computer connected to IOGEAR Secure KVM Switch should only be powered on after all of the
device (Video, USB, and audio) are securely connected
Secure Operation and Administration
Please refer to Operation section for detail administrator functions.