User's Manual

29
NOTE: (1) If the scanning stops on an empty port, or one where the computer is attached but is powered off, the monitor screen will be blank,and the
mouse and keyboard will have no effect. To recover, key in the
HotKey
sequence (see
HotKey Selection
, above) for any Port ID that has an
active PC attached.
(2) As the OSD cycles through the selected ports, an S appears in front of the Port ID display as each computer is accessed to indicate that the
computer is being accessed under
Quick View Scan Mode.
F3 List:
This function brings up a submenu that lets you broaden on arrow the scope of which ports the OSD lists. The choices and
their meanings are given in the following table. To make a choice, move the Highlight Bar to it, then press [Enter]. An icon
appears before the choice to indicate that it is the currently selected one.
Choice: Meaning
All: Lists the Port ID numbers and Names (if names have been specified -see F5) of all the ports on the installation.
Qview: Lists only the ports that have been selected for Quick View (see F4, below).
Powered On + QView: Lists only the ports that have been selected for Quick View scanning (see F4, below), and that have their attached PCs Powered
On.
QView+ Name: Lists only he ports that have been selected for Quick View scanning (see F4, below), and have been assigned names (see F5,
below).
Name: Lists only the ports that have been assigned names (see F5, below).
Powered On: Lists only the ports that have their attached PCs Powered On.
Function Keys