User's Manual
Table Of Contents
- _GoBack
- FCC Information
- User Notice
- Package Content
- About This Manual
- Chapter 1 - Introduction
- Overview
- Chapter 2 - Hardware Setup
- Chapter 3 - Operation
- Appendix
- Specification - DisplayPort Single View Secure KVM
- Specification - DisplayPort Dual View Secure KVM
- Specification - HDMI Single View Secure KVM
- Specification - HDMI Dual View Secure KVM
- Specification - DVI Single View Secure KVM
- Specification - DVI Dual View Secure KVM
- Limited Warranty
24
Operation
Chassis Intrusion Detection
The IOGEAR Secure KVM Switch will become inoperable and the Front Panel LEDs (except for the
Power LED) will ash constantly when a chassis intrusion, such as the cover being removed, is detected.
This is to prevent malicious tampering with IOGEAR Secure KVM Switch.
The Intrusion Detection is an active always-on function. If all of the front panel LEDs (except for Power
LED) ash continuously or the switch’s enclosure appears to be breached, avoid using this product and
contact your IOGEAR dealer.
Smart Card and CAC Reader
The USB Smart Card / CAC reader function of each port can be enabled or disabled (enabled by default).
Press the port selection pushbutton for more than 3 seconds and release it, and the CAC reader function
of that port will be enabled/disabled (this is a toggle feature). The CAC LEDs are used to indicate the
CAC reader operation status.
If the CAC reader function is to be disabled for certain PCs, it is advised not to connect a USB CAC cable
in the installation.
Please refer to Administrator’s Guide for details.