Quick Start Guide 4x2 Port HD Switch Splitter GHSW8242 PKG-Q1202
Package Content 1 x GHSW8242 4x2 Port Switch Splitter 1 x IR Remote Control Unit 1 x Power Adapter 1 x IR Receiver Cable 1 x Foot Kit 1 x Rack Mounting Kit 1 x User Manual 1 x Quick Start Guide Requirements Cables • 4 HDMI cables (available separately) Source Device • HDMI Type A output connector(s) Note: A DVI/HDMI adapter is required when connecting a DVI source device. Note: 1.
Start Here! GHSW8242 Overview Front View 1. Port LEDs 2. Port Selection Buttons 3. ARC LED 4. ARC button 5. Power LED 6. Power Button 7. IR Receiver 1 3 5 4x2 HD Audio / Video Switch Splitter ARC POWER IR 2 Back View 1. Grounding Terminal 2. Power Jack 3. IR Extender Port 1 2 3 4 6 4. RS-232 Serial Port 5. Stereo Audio Ports 6. Digital Audio out Ports 4 5 6 7 Remote Control Top View 1. Up / Down / Left / Right Buttons 2. OK 3. On 4. Off 5. Port Selection Buttons 1~4 6. Menu 7. Info 8.
Installation Note: Make sure your source devices and display are powered off before you start. Step 1 Use an HDMI cable to connect the HDMI input port on the video display device to the HDMI output port on the rear of the GHSW8242. Step 4 Connect your audio devices (such as speakers or AVRs) to the Stereo Audio Ports or Digital Audio Ports. Step 5 (optional) To edit the GHSW8242 system settings through the RS-232 port, connect the hardware / software controller here.
Serial Port (RS-232) Command List Switch Port Commands 1. Switch Command (and) Input(and)Port Number [Enter] For example, to switch to the input port 01, input the following: sw i01 [Enter] 2. Switch Command (and) Port Sequence [Enter] For example, to switch to the next port (+), input the following: sw + [Enter] Note: Each command string can be separated with a [Space]. For a complete list of RS232 commands, please see user guide.
Rack Mounting Step 1 Remove the screws from the left and right sides of the switch (2 screws total) near the front of the switch. ARC POWE R IR Step 2 Use the M3 x 8 Phillips hex head screws supplied with the rack mounting kit to screw the rack mounting brackets into the sides near the front of the unit. ARC POWE R IR Final Step Place the switch in the rack. Position it so that the holes in the mounting brackets line up with the holes in the rack.
Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential setting. This product generates, uses, and can radiate radio frequency energy and, if not installed and used as directed, it may cause harmful interference to radio communications.
